Ford F-150 Questions Any type
1994 F150 Wanders At Highway Speeds
You have to constantly adjust the steering wheel to stay in the road. Front end alignment, tie rods, main drag link, steering box, and ball joints are good.
Value Of My Truck
I have a 1988 Ford f-150 it's 2wd, SWB, single cab, fuel injection 302. And it only has 94,500 original miles on it. I just did a tune up on it . It's not using a bit of oil. I was wondering what ...
Does A Motor Of A 2004 Expedition 5.4 Fit A 2005 F 150 5.4 Lariat
Does a motor of a 2004 expedition 5.4 fit a 2005 f 150 5.4 lariat My motor blew out and don't have to much money to buy a new truck
I Have A 2003 Ford F-150, 5.4 Engine.
I added a pint of some foreign liquid accidently. So I had the oil changed and the filter changed. It's tapping now and the oil gauge in the dash shows low oil pressure.
Firing Order
I have a 1984 Ford F-150. I need the firing order.
Mechanical
I have changed my fuel pump and filters. Why won't my 1979 F-150 start
I Get 1988 Ford 150 It Wiil Run But It One Day And It Start Miss The Day
I like to know what to do
Break Lights Out
Break lights out.... They only work when u have lights on and use left turn signal, other wise no break lights, anyone know what it could be?
I Have A 1985 F150 Automatic And The Top Starter Point Keeps Breaking. Any ...
I took my truck in for an alignment then the top mounting point in the starter broke. We replaced it about two weeks ago and it broke the same way again. Any resolutions.
77 F150 4wd
Did a 77 f150 4wdcome with a mid ship fuel tank
Truck Will Turn Over And Want To Start But Won't Start
changed plugs will turn over but won't start and fuel pump changed
Vaccume Leak?
Hi I have a 2001 f150 5.4 triton xlt and I had a bad coolant leak for a while and it also threw a bank 1 running too lean code. I knew the leak was from the intake gasket so i just bought a whole ...
I Have A 2008 Ford F-150. Can The Bearings Be Replaced Only Or Do You Have ...
I have heard from different people that you have to purchase the entire hub with the bearings already in place. Then some say you can have the races pressed out and the new bearings pressed in. I be...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.