Ford Bantam Questions Any type
My Ford Bantam Bakkie Will Not Start When You Turn On The Ignition Key,engi...
lawrence.wesman@gmail.com My Ford Bantam Bakkie will not start when you turn on the ignition key,engine is dead.
Hi To All U, How Do I Change The Cluch Kits For2003 Ford Bantamrocam.thanx
the car does not clutch i checked the master cylinder is not of any kind i know,went to them spare shops them also surprised to that master cylinder,open it cannot manage
Please Help- Ford Bantam
I just bought a '08 Ford Bantam 1.3i as a daily comuter as I work in JHB city centre and do not wish to drive around here with my Toyota Fortuner.I am use to dring a diesel so the petrol thing is a bi...
How To Connect Bantam AC Switch
Bantam 2006 1.6i A/C & Recirc switch came off, each switch has 5 pins(1,2,4,6 & 8) but there are 4 wires for each. AC has red,orange,violet and black&white Air Rec orange,violet,black and green
My Ford Bantm 2004 Did Not Want To Clutch When I Tried To Put Gear 3 And Wh...
Car does not want to clutch.My ford bantam 2004 did not want to clutch when i tried to put gear 3 and when i checked the clutch pedal so weak like it's got no power .When i openend the hood there sign...
Hw True It Is That The Timing Belt Of A Ford Bantam 2005 Model Is A Chain. ...
The kilometer on my bantam is now 300
Spark Plugs Keep Burning Time And Again
Good Day, I have a problem with a ford bantam bukkie rocam 1.3 2004 model, it keeps burning spark plugs expecially in cylinder No 4, can you please advise what might b the problem? i have already chan...
What Causes My Brakes To Shudder When I Push The Pedal To Brake
I have had to replace my front wheel bearings twice within 2 months and since then the front left brake shudders badly when the brake pedal is pressed. Could the brake discs be damaged in any way.
Where Do I Find The Fuel Pump Relay
1997 ford bantam 160 i
Where Can I Find An Owners Manual?
Where might I find an owner's manual for a Ford Bantam, 2008 model, petrol engine. 1.3i
The Revs On My Bantam 1.6i XLT Is Hunting Especially When The Engine Is Col...
i have done 392000km with my ford bantam 1.6i XLT but recently the revs started hunting between 750 and 1500rpm. it looks like the engine is taking up strain as indicated by the diming of the interior...
How Do I Remove The Sump Of A 1.3l Rocam Engine Of A 2003 Ford Bantam Bakki...
I don't want to remove the engine from the car unless I have to, but will do so if its the easier way of getting the sump off. Quite apart from that, I ESPECIALLY don't want to disconnect the inlet- &...
Heating System Is Not Working
I have a 2008 1.3 bantam and my heater is only blowing cold air. what could be the matter?
Fitted 1997 Fiesta 1400i Engine With Loom Into 1994 Bantam Bakkie.
Bakkie has more power now but as soon as engine reach normal temp, it misses and backfires. I then have to turn engine off for around 10 sec and it's ok again when i restart. while it misses i remov...
Is My Altenator Busy Saying Goodbye ?
Hi guys, My battery service light came on about a week ago, on low revs it stays on..above 2000rpm it goes off. Now the battery is completely dead ! Does my altenator need repair..bushes or something ...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.