Ford Bantam Questions Any type
Ford rocam 2009 not starting when cranking but starts when push started. Any ide ?
Hi All, new to this forum, but this is now where I am forced to try and get some guidance on the issue I have. My Bantam has now stated with this weird overheating problem about 3 months ago. I woul...
Hello can i change my 2008 bantam headlights to the 2009 headlights? are they the same size, I have problem of getting 2008 replacemnt headlights in Lesotho
It goes but only start too preform after 5rpm dont know what the problem is and when it's hot its idling drops a bit then oil light goes on and of .any advise pleas
Lost my immobiliser at shopping center,I only need it to start the car, it activates the ignition, how do I over ride it to start
Good day. I'm having a problem with my Ford Bantam 1.3 rocam. I've changed my head gaskets and replace my oil and oil filters and I've torque the head the nm's I should've. I ensemble everything a...
I drive a ford bantam when the engine is hot it jerks and switches off then I must wait for 10 to 15mins then it drives again
After replacement of key transceiver loom do I have to reprogram the new transceiver.
Hi i have a bantam rocam 1.3 off gear it its idling is not steady and when i revv it the RPMs just drop completely....please assist
I have 2008 Ford Bantam rocam 1.3. It cranks but no start. It has an older computer box used in pre 2007 bantams. I have changed the flywheel to match the ecu as advised and used a 36-1 tooth fl...
I have a 2006 Ford Bantam rocam,it does not want to go in gear when the car is on,the clutch is stiff like always.what can it be please
Hi. I have a 2008 ford bantam rocam 1.3. It cranks and has fuel and spark but no start. I'm using a 1.6 ecu for pre 2007 bantams. I also changed the flywheel to match the ecu 36-1 teeth. Does the ...
My ford bantum rocam gives on but does not want to start or even crank the engine,what l noticed again the is a small red light near the watch that switches on when l turn on the car then off and ...
Kindly assist. I have ford bantam 1.6 xlt rocam 2011 model. It used to jerk while in motion when I accelarated. I was advised to change the coil; spark- plugs and fuel filter of which I did but there...
My bantam won't switch off After starting what can cause that?
Hi all i recently bought a non runner Bantam with high mileage and decided to completely overhaul the engine, now i am experiencing 2 problems, not sure if its related. Problem 1 the bakkie is hard...
My bantam doesn't start when it is warm, it also does not get feul at the injectors in front. We replaced the feul pump and the cranck sensor, but it still does the same? Any suggestions?
The service intervals on my 2004 Bantam 1.3 with rocam engine is 15000 km. Must the plugs TR6B-10 also be replaced every 15000 km?? There is no 2004 model option below so I have selected 1995
The car started after the top gasket was replaced, after the test drive there was another pipe leaking we replaced that pipe the next day then the car did not want to start, it cranks but no fire, ...
Search Ford Bantam Questions
Ford Bantam Experts
Find great deals from top-rated dealersSearch