in my 2011 Honda accord the switch that controls my drivers side window on my master control has stopped working.. is it possible to switch the passenger control with the broken driver control.. the other three on the master control are still working properly and I have already eliminated possibility of it being the motor..??

usually when a window switch on driver side stops working but the motor is still working the problem is where the wires come out of the door to the driver door post sometimes you can just grab the big chunk of wires and with the switch activated shake the wire harness and chances are the window will start to move

What archiehill says is true...but usually only happens on older cars than a 2011. If it looks like this, it comes as a unit

Can i get instructions step by step on how to install the window on driver side in my 2011 honda accord

How do I install this unit?

Here's the programming instructions. Note: Entering the programming mode cancels all learned keyless remotes, so none of the previously programmed remotes will work. You must reprogram all of the keyless remotes once you are in the programming mode. You must complete each step within 5 seconds of the previous step to keep the system from exiting the programming mode. 1. Turn ignition switch to ON (II) 2. Press the LOCK or UNOCK button on one of the remotes. (An unprogrammed remote can be used for this step.) 3. Turn ignition switch to LOCK (0) 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step 2 5. Turn the ignition switch to ON (II) 6. Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirm you are in programming mode. 7. Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote. 8. Turn the ignition switch to LOCK (0) to exit programming mode. 9. Test remote(s) I hope this helps! Here's a video on removal https://youtu.be/M0I6V62QDIQ