Asked by Tonicolburn Oct 01, 2016 at 04:17 PM about the 2003 Ford Explorer XLT Sport V6
Question type: Maintenance & Repair
Where is the pcm/ecm located
Unless you have a specific piece of test equipment there is nothing you can do. Even if you replace it with a new one it will have to be programmed.
Where is the pcm/ecm located
2003 Ford Explorer XLT Sport V6
-
Maintenance & Repair
My sons explorer was missing really badly and had no power when driving. It would start and run decent in park. The ecn was removed and terminals cleaned. Once it was reinstalled the vehicle is no...
2002 Ford Explorer XLT 4WD
-
Maintenance & Repair
Didn't have OD flashing till my PCM went bad. Dealer confirmed PCM was bad. I replaced PCM with a refurbished PCM. OD is still flashing and now the idle is up to high so shifting into drive sounds l...
2002 Ford Explorer XLT 4WD
-
Maintenance & Repair
Ford dealership telling me it will cost at least $1200 to replace PCM in my 2002 Ford Explorer.
2002 Ford Explorer XLT
-
Maintenance & Repair
My anti theft light is flashing rapidly. I only get 5 volts at my fuel pump? The pats code is 12 and says my pcm is malfunctioning. I have got the truck to start a few times and even ran for half...
2000 Ford Explorer
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.