RH headlight low beam will not work since the blow out of both front and rear same side. Replaced and rear is fine but the low beam right won't work. High beam is fine?

RH headlight low beam will not work since the blow out of both front and rear same side. Replaced and rear is fine but the low beam right won't work. High beam is fine? 3 Answers

I have a2003 PT Cruiser, I drove it home from work on Sunday and parked in the driveway. Monday I went to go to the store and it wouldn't start but is turning over. I pulled the starter and battery and the plugs. The started tested good and battery bad so I replaced it. Replaced the air filter and plugs too and then it still wont start! It still turns over but wont fire. I checked Fuel pressure at the test port at 80 psi and compression at the cylinder, all good. I am out of ideas and money is tight, what am I missing? Any suggestions? 2 Answers

P T Cruiser won't start

at times my 02 PT Cruiser will crank nicely but will not start When doors are locked then unlocked a click can be heard under the center of the dash and the it will start So what is the issue 1 Answer

02 PT often will crank but not start, if doors are locked then unlocked it will start, the other day it shut down while driving down the road, we did the lock unlock on the doors and it started up So...

2001 P-T Cruiser A/C not blowing cold . High side pressure line is cool , low side line not cool . 1 Answer

Pressure seems about the same in liquid line and low side line , but at the hot gas port on compressor the pressure go up to 400 lbs. and then the compressor shuts off.

headlights stuck on high beam 1 Answer

When I turn my lights on, I can't switch from high beam to low