Wont start after engine replace
Asked by Sean Apr 17, 2016 at 11:33 PM about the 1996 Chevrolet Blazer LT 4-Door 4WD
Question type: Maintenance & Repair
Replaced 4.3 v6. It's getting gas and has spark but will not fire up. Doesn't even stumble. I'm on
a no budget.That's lower than low budget.so no new parts all over it. But what I've checked
seems to check out. Please help. Starting to feel like blowing its head off.
3 Answers
yeah, you are starting to see the problem that so many people face these days- complicated 21st Century cars with a zillion parts to go wrong, and being poverty stricken- myself, I am working on this unpleasant situation by owning a simple, old machine- and riding a bicycle- good luck- keep trying, hope you figure it out- or just scrap the junk and start over-
Well you are going to have to go over the basics, make sure there is the proper fuel pressure, spark to the plugs, & the timing set correctly.
Re-reading your post, is this a rebuilt engine? or some junker you found. Check the compression on the cylinders.
