Make sure battery has a full charge and battery connections all good. Any electrical component, I want to check voltage and ground for that component. The instrument cluster, I saw two fuses, gage fuse and cluster fuse, interior fuse box. Both those fuses goes hot with key on, so if problem with feed to or from ignition switch, that will cause problems. You can use test light to check for voltage at those fuses, key on. The ground for instrument cluster is the black wire. Because you said vehicle starts and stalls, makes me wonder about your security system? Any applicable trouble codes?
For a 2001 Chevy s10 when starting the truck it all the gauges didn’t work. Driving back home the truck died, and now it turns on dies. What could the problem be?
2001 Chevrolet S-10 LB RWD
-
Maintenance & Repair
Has plenty of gas in tank, when turns key, lights don't dim, engine turns over but will not start up. Any ideas?
1999 Chevrolet S-10 LS Extended Cab RWD
-
Maintenance & Repair
I had the vehicle in 4WD and pushed the button to switch back to 2WD. It went back into 2WD but the indicator light says 4WD. No matter which button I push it says 4WD, but it is still in 2WD. Any ...
2004 Chevrolet S-10 LS Crew Cab 4WD
-
Maintenance & Repair
02s10 all dash lights on until unhook battery and no functioning gauges. Is it a bad headlight switch?
2002 Chevrolet S-10 LS Crew Cab 4WD
-
Maintenance & Repair
My blower motor would not come on when switch is turned on. Less than three hours before it was working fine with no noises from the blower motor. It is 0 F here, would that have anything to do with...
2000 Chevrolet S-10 LS LB RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.