Asked by Corsa_2515 Feb 08, 2017 at 06:07 AM about the 1996 Toyota Camry LE
Question type: Maintenance & Repair
Brake pads/shoes have plenty of "meat" left on them but vehicle is hard to stop. All calipers, etc. functioning optimally, hydraulic system flushed.
It may be a problem with the brake booster that the master cylinder is attached too. This is your power brake assist.
Check the amount of vacuum at hose that attaches to your brake booster. It needs to be at least 18 inches of vacuum.
Brake pads/shoes have plenty of "meat" left on them but vehicle is hard to stop. All calipers, etc. functioning optimally, hydraulic system flushed.
1996 Toyota Camry LE
-
Maintenance & Repair
My 2015 Camry was stolen, it was recovered with a rear driver side flat tire ,the front tire had a bent rim and the check vehicle stability system light is on. The car drives however my steering wh...
2015 Toyota Camry SE
-
Maintenance & Repair
ANY MECHANICS PLEASE HELP ME WITH THIS SITUATION. My small car is working fine, but battery wasn't working. Need to do jump start every time i want to go out. I bought a new battery and during install...
2008 Toyota Camry SE
-
Maintenance & Repair
How long before i change my brake pads on a toyota camry 2007 xle V6? How long before i service(oil & oil filter) considering the fact that car is about 5yrs and over 50,000 in mileage?
2007 Toyota Camry XLE V6
-
Maintenance & Repair
I checked all 4 wheels this weekend and pads are fine. I bled the brakes but the brake pedal is still soft and pushes in too far. It only squeals at last point of stop and not every time. Any sugge...
2003 Toyota Camry LE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.