Asked by fordman1965 Feb 07, 2016 at 05:18 PM about the 2002 Ford Focus ZX5
Question type: Maintenance & Repair
There is a speed or wheel sensor down there, the wire may be off, or it is broken.
If you find someone who has a scanner that can read ABS code, that would tell you right where it is.
2002 Ford Focus ZX5
-
Maintenance & Repair
replaced rear wheel bearings on 2002 Focus, now brakes not completely releasing, get hot and the ABS light is on, Also was on when bearing went out.
2002 Ford Focus SE Wagon
-
Maintenance & Repair
My mechanic just replaced my starter and now the check engine light is on. Prior to picking up my car, he asked me if the light was on when I brought it in. I told him absolutely NOT He, of course...
2010 Ford Focus SE
-
Maintenance & Repair
Could it be the ignition switch? Recently sometimes I have to wiggle the key before it will catch and crank. Or could I have a relay or fuses go out at once
2002 Ford Focus ZTS
-
Maintenance & Repair
I have an 06 ford focus 2.0 zx4. CEL popped on and autozone ran it as the bottom o2 sensor needed to be replaced. I rented the tool and did it myself. When replacing it i made a horrible mistake ...
2006 Ford Focus ZX4 SE
-
Maintenance & Repair
CarGurus has 489 nationwide Focus listings starting at $1,250.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.