will a series 3 differential from a 1980 307:1 gear fit into a 1981 batwing?, am i able to change those 307 gears to a 391?

Asked by GuruZS9PZ Nov 02, 2017 at 06:29 PM about the 1981 Chevrolet Corvette Coupe RWD

Question type: Maintenance & Repair

I have a 1981 vette with stock 287:1 rear end gears, would like to use a 1980 differential with stock 307:1 gears (3 series) and put in 392:1 gears. will this work?

50,765

John answered 6 years ago

Yes but you might consider an aftermarket set-up. Stronger and more reliable. many on the market out there. OE exterior is or should be the same, the interior is the only difference and it's the gears. Race cars use a "quick gear exchange" set up if you want to change gears to fit your moods.

Mark helpful

Your Answer:

will a series 3 differential from a 1980 307:1 gear fit into a 1981 batwing?, am i able to change those 307 gears to a 391? 1 Answer

I have a 1981 vette with stock 287:1 rear end gears, would like to use a 1980 differential with stock 307:1 gears (3 series) and put in 392:1 gears. will this work?

1981 Chevrolet Corvette Coupe RWD

-

Maintenance & Repair
I have a 1980 Corvette-whos wipers don't really want to work, H E L P !! 1 Answer

I have already replace the Wiper motor both under the hood & the one one the dash. I was told either one of these would be the problem. No dice! The problem is this, the wipers work, but I have no in...

1980 Chevrolet Corvette Coupe

-

Maintenance & Repair
I have a 86 corvette after driving for 3/4 of a mile it will want to shut of but I can keep it running by giving it some throttle 4 Answers

I've replaced the wires ,the fuel pump ,the module the cap,rotor,plugs,fuel filter. If i turn it of and start it back up it will run for another 100 ft and start acting up again. It's early 86 Can an...

1986 Chevrolet Corvette Coupe RWD

-

Maintenance & Repair
How do I get a headlight to shut 7 Answers

When I shut off headlights on my 2000 Corvette, both close then the drivers side opens again but the light is off. How do I get it to shut? The passenger side works fine. thanks

2000 Chevrolet Corvette Coupe RWD

-

Maintenance & Repair
Hey all. I have a 1975 Corvette C3. I just did something stupid. I pulled my alternator to have it checked; however I did not disconnect the battery. As I disconnected the battery cable from alternator, it arc'ed badly. After having the alternator checked, upon reinstalling it, I have no power at all. I'm trying to determine which fuse, or relay, or whatever I have blown. Any help is appreciated. I do not have a fuse box layout. Thanks Apostle Smith 2 Answers

As stated in the subject question, but again, I have a 1975 Corvette C3. I ust did something stupid. I pulled my alternator to have it checked; however, I failed to disconnect the battery first, ...

1975 Chevrolet Corvette Coupe

-

Maintenance & Repair

Used Chevrolet Camaro

15 Great Deals out of 465 listings starting at $11,999

Used Ford Mustang

35 Great Deals out of 1,603 listings starting at $7,999

Used Dodge Challenger

18 Great Deals out of 767 listings starting at $11,480

Used Dodge Charger

42 Great Deals out of 857 listings starting at $5,995

Used Porsche 911

17 Great Deals out of 244 listings starting at $22,980

Used Ford F-150

319 Great Deals out of 13,512 listings starting at $3,888

Used BMW 3 Series

60 Great Deals out of 1,160 listings starting at $2,500

Used Toyota Supra

4 Great Deals out of 44 listings starting at $50,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

will a series 3 differential from a 1980 307:1 gear fit into a 1981 batwing?, am i able to change those 307 gears to a 391?

1 Answer

Your Answer:

Shortcuts

Search Chevrolet Corvette Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

will a series 3 differential from a 1980 307:1 gear fit into a 1981 batwing?, am i able to change those 307 gears to a 391?

1 Answer

Your Answer:

Related Questions