The window washer only squirts on one side, is it clogged or does the entire hose need to be replaced? Is it difficult to replace if needed?

The window washer only squirts on one side, is it clogged or does the entire hose need to be replaced? Is it difficult to replace if needed? 2 Answers

1999 Honda CR-V will not start. I changed the fuel pump, fuel pressure regulator along with the fuel filter and the main relay but the vehicle still will not start. The distributor along with the coil was replaced about two months ago, spark is ok. Sometimes the vehicle start for a few second but the engine stalls as if the timming is off but the timing is ok, also sometimes it back fires and when it does the vacuum hose that is connected to the fuel pressure regulator comes off from the regulator. I check the injectors and they are getting power. I disconnected the exhaust thinking of the catalytic but still no start. Could it be the computer? Any help on this matter will be greatly appreciated. Thanks 8 Answers

1999 Honda CR-V will not start. I changed the fuel pump, fuel pressure regulator along with the fuel filter and the main relay but the vehicle still will not start. The distributor along with the coil...

Is it bad to take apart the dashboard in a brand new CRV to fix a cosmetic issue regarding the passenger side airbag cover? 3 Answers

I recently purchased a 2013 Honda CRV. After a day i noticed that the passenger side airbag panel did not fit flush with the dashboard. I took it to the dealer and they said they can fix it but th...

Wanting to change starter relay fuse, which one is it. 16 Answers

Wanting to replace starter relay fuse in 2015 crv which one is it.

This is a long one. I went in to get my breaks fixed about a month ago. They shaved down the rotors on my two back tires. Well, they checked my other brakes, but forgot to tighten the lug nuts on my front left tire, and it ended up falling off while I was driving. They fixed resulting issues, free of charge. Then yesterday, it sounded like the back brakes were going again, so I took it back to them. They said the BACK brakes, which were supposed to have been fixed originally, a month ago, were metal on metal (they re-graded/shaved down the rotors). They went ahead and replaced the back rotors and pads, but I'm curious... Could the front tire falling off have caused the back brakes to wear out? Or did they just not do a good job originally? Or could something else be causing the brakes to wear so quickly? 11 Answers

This is a long one. I went in to get my breaks fixed about a month ago. They shaved down the rotors on my two back tires. Well, they checked my other brakes, but forgot to tighten the lug nuts on my...