The computer in the vehicle (ECM) needs to be reprogrammed if there has been a serious malfunction in the system. Also, changes in the intake and exhaust systems need to be reprogrammed. It is not required to take the vehicle to the dealer for this purpose, but it is certainly necessary that the person doing the reprogramming is knowledgeable in the field.
Has anyone ever heard that you had to take to dealer to have the system reprogrammed?
Dodge RAM 2500
-
Maintenance & Repair
Have a 2008 Ram 2500 with a 6.7 cummins that has a p0562 code (system low voltage). Had a bad alternator (replaced), had a bad regulator (replaced). Now it has this code. The drivers side battery...
2008 Dodge RAM 2500 SLT Mega Cab RWD
-
Maintenance & Repair
2003 Dodge Ram 2500 Quad Cab 4x4 HEMI acceleration problems started after I put dual exhaust muffler system on it
2003 Dodge RAM 2500
-
Maintenance & Repair
when fuel tank gets to half full or lower it starves for fuel and starts stalling. It has a in tank fuel pump
2002 Dodge RAM 2500 SLT LB 4WD
-
Maintenance & Repair
started fine in the a.m. just not later that day. When key is turned there is not even a click. Mechanic asked if I had a 2nd key which I don't so what are some ways to get the security codes?
2007 Dodge RAM 2500 ST Quad Cab 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.