When you replaced the resistor, did you replace the pigtail that goes into it too? Those will tend to melt on the inside and short out. Very common problem.
Mine is melted and went to get replacement and there is a difference between auto and manual controls so how do you know different?
i have replaced blower motor and resistor and still wont blow . it has power to plug that goes to resistor but no power out of resistor when plugged in what could be my problem?
2004 GMC Envoy
-
Maintenance & Repair
The original HVAC blower motor died in my Envoy. We replaced it with a brand new one. Was working for about a week and now has stopped. When I turn the heater on while idling it bogs down and bo...
2006 GMC Envoy SLE 4WD
-
Maintenance & Repair
I have power and lights but it wont turn over
2004 GMC Envoy
-
Maintenance & Repair
I have had the transmission rebuilt and the speedometer stopped working. Replaced the speed sensor and the odometer went out again . Checked the wiring and everything is fine. Brand new speed sensor...
2004 GMC Envoy 4 Dr SLE 4WD SUV
-
Maintenance & Repair
My blower motor will not shut off even with the key out I changed the temperature control module it is the digital one I changed the blower control module still the blower will not shut off
2004 GMC Envoy 4 Dr SLE SUV
-
Maintenance & Repair
CarGurus has 3 nationwide Envoy listings starting at $6,900.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.