Like I've said before, with enough money anything is possible. It would take a lot of time and knowhow to swap over to a diesel. You would have to change so much of the electrical components and wiring as well as the engine and transmission.
T.A. is right. It can be be done. If you insist I recommend the Cummins 6 cylinder diesel engine that Dodge uses. But at what cost?
1985 Chevrolet C/K 10
-
General
I'm looking at getting a restored 1984 cheavy Silverado, but it needs a new engin. I love cheavys but it would be my 1st project car . Dose any one have any suggestions about what engin I could dr...
1984 Chevrolet C/K 10 Silverado RWD
-
General
The manifold is warped on oem and I believe it is typical for that year. Is there another engine that could fit using existing mounts and transmission?
1978 Chevrolet C/K 10
-
General
I have a 1979 k10 pickup with a 6 inch rough country lift kit and 35 inch tires it has a edelbrock carb and I wanna know what gears I need to put in for the most power and fuel millage together
1979 Chevrolet C/K 10
-
General
Drive truck for 3 weeks ran fine transmission will go into 3rd sometimes sometimes it won't. I replace the vacuum assist and transmission flush filter new fluids
1978 Chevrolet C/K 10 Custom Deluxe RWD
-
General
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.