Mazda Protege Questions Any type
98 Mazda Protege Tires
Im wondering if R14 195/70 tires would fit on my '98 Mazda Protege ES. Currently there are R14 185/65 on there. Hopefully someone can help me out.
How Do I Get My 2003 Mazda Protege LX To Pick Up Speed Faster?
My Mazda takes a while to pick up speed and I was wondering if there was anything I could do to help it speed up quicker?
Does Mazda Protege Of 2002 Have Anti-lock Brakes?
I need to know this as i'm applying for the insurance. Thanks!
My 2003 Mazda Protege Wont Start PLEASE HELP!!!!!
hello everyone. I have a 2003 Mazda Protege and for several days now my Mazda has not been driving right. Its been very slow getting up hills and the check engine light is on then it will blink then...
Same Vehicle And Now The Thermostat Is Rising And Found Droplets Of Antifre...
Same vehicle and now the thermostat is rising and found droplets of antifreeze fluid under the left side of wheelwell that can't be good can it?
Bad Pcv Hose Cause Of Stalling?
I have a Mazda protege 1991 and a few weeks ago I filled the tank and the car stalled on me about 2 minutes later. I can restart after a few seconds but it won't last long before it stalls again....
Is It Obvious If A Cars Frame Is Warped????
I just bought a 1996 mazda protege. It needed a little work. Its been wrecked...... minor damage......I hope. It needed rear wheel barring.... I fixed that slightly. I put new tires on. Now, It's ...
Fouling Plugs
My 99 Mazda Protege has startup issues and I need help diagnosing..I was told possiblke Headgasket so before addressing that, Temp gauge was up and down without overheating but losing some antifreez...
Noisy Cab And Vibration In Steering Wheel
Very loud in cab of car, vibration in steering wheel?I have a 2003 Mazda Protege. I had the front drivers side axle and steering knuckle replaced, since then the cab noise and vibration in the ste...
2003 Mazda Protege5 Blown Fuse
my licence plate bulbs went out, and ever since then I've had the fuse for my dash and running lights go out any advice would be grealy appreciated
If You Use An OBDII Scan Tool To Delete Diagnostic Trouble Code(s), Then Ho...
When you plug in an OBDII scan tool it should say: DTC 0 and IM Ready Yes But after you get the check engin light and use the scanner to delete it it says: DTC 0 and IM Ready No. How can you get it ...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.