Dodge RAM 1500 Questions Any type

99 Dodge Ram 1500

I have a 1999 dodge ram 1500 5.2 magnum, i replaced plugs wires cap rotor and cam sensor and coil about 4 months ago ran great until tester i came out to go to work start the truck up and check en...

1999 Ram 1500 Starts But Immediately Dies

Ram 1500 runs but immediately dies

About A 99 Dodge Ram

Wher can I buy a Body for my 99 dodge ram motor 4 by 4 and what other years are compatible

Headlights

Driver side headlight is not working bulbs seem to be in good condition. Passenger headlights low/high and turn signal all work including both fog lights any suggestions?

Hp

I have a 02 ram 1500 been thinking about swapping the motor for something faster then the 4.7 thats in it but im not sure whatbwould work good in it and also changing the axels and pretty much ever...

Riddle To The Mac

Okay. I have a 2000 dodge ram 1500. It was running before i pulled the transmission to change it. After i got the new transmission in now it will not start. It will turn over but it wont start. Ive...

Oil Dip Dticktube

how foireplaceoildipdticktube

High Idle

I changed the spark plugs in my 2003 dodge 1500 4.7l V8, which was a pain in the ass, and now it idles at 2000. Any idea what's wrong and how to fix it?

HOW TO REPLACE THE PARTS WHERE THERE IS A RUSTED HOLE AND REPLACE THE TRUCK...

Transmission Swapping

I have a 96 Dodge ram truck with 5.2 I'm getting a 97 Dodge van 3500 with a 5.2 will the transmission swap out

Misfiring While Driving

Runs and drives. But misfires and is groggy while driving.what is causing this

Camshaft Sensor

Ok so I have a 97 dodge 1500 4x4 just changed the clutch and I broke the camshaft sensor so I replaced it but now it keeps blowing my engine fuse also I stuck a 60 amp fuse in it and ran fine what...

03 Dodge Ram 1500

i have an 03 dodge ram 1500 wit the 4.7 cylinders 1,2,3,6 will not fire but all has good compression

Bleeding The Brakes But Still Have No Pedal Aftr Bleeding

So i had to change the calupers on my 2000-1500 -5.9, dodge ram, took both calipers off nd didnt clamp line nd the master cylinder was empty by the time i was ready to bleed, now that i bled them ...

Dodge Problem

My Truck use to stall while I was driving and I had hard Time to Start IT back .. I change all the sparksplug, ignition coil and all the coil, the camshaf sensor, the crankshaft sensor, speed cir...

Ram Hemi 2006 4×4 5.7litter

JUST BOUGHT A USED 2006 RAM HEMI 4×4 5.7 ITS BARELY BEEN 3 WEEKS N YESTERDAY I NOTICED MY BRAKES WHERE SQUEAKING. TODAY WHILE MAKING A RIGHT TURN I LOST CONTROL OF MY TRUCK N SLAMMED INTO A STR...

99 Ram 1500 Interchangeable Part

Soft Pedal After Brake Job

I replaced rotors, calipers, and pads on all corners. Have bleed the brakes 6 or 7 times and the pedal is still soft going to the floor. The pedal gets pressure after 3 or 4 pumps and will hold it u...

Radiator Clutch Fans?

This is also a pricing and repair question. Unfortunately, as a woman, I feel as though the mechanics often take advantage of my lack of knowledge. Yesterday, I drove about 90 mins from home, only to...

2nd Gen Dodge

I have a 97 ram 1500 that has been swapped from a 5.2 to a 5.9 the pcm is bad. Should I buy the 5.9 pcm or 5.2? Does it really need to be flashed? (Flashing cost the same price as the pcm)