my fan does not work and over heats. the constent control relay module fuse is blown. what do i need to replace?

my fan does not work and over heats. the constent control relay module fuse is blown. what do i need to replace? 1 Answer

How do I replace the electric window control switch 1 Answer

None of my electric windows will not work from the drivers control panel. The drivers window went down but want go back up. Do I just need to replace the motors and wiring harnesses? 1968 Ford Thun...

What does the CCRM control on a 4.6L V8? 1 Answer

I replaced it because it failed and caused my Engine Cooling fan to burn out and the cooling fan only worked when the air conditioner was on. After replacing it, the cooling fan now comes on when the ...

i have a 96 t bird 4.6 liter it runs about 30miles the check engine light comes on then at 100 or 150 miles the control module burns up . no fuel pump sound it dont start. theres been 3 installed and repeats itself i had a engine code reader put on it it gives code p1443 can you tell me what i need to get this fixed thanks terry 1 Answer

what is diagnosis code mean and can i buy this part from the dealer thanks terry

How hard is it to replace the distributor Hall effect sensor? 1 Answer

'92 Tbird, 3.8L V6 After 164k miles, or so, the car wouldn't start. No spark out of the coil. Replaced the Ignition Control module, and nothing. Careful inspection under the Hall effect reluctor ...