Trying to replace it? Should be drivers side, under cab on inside of frame. May need a screwdriver and line remover tools (sold by most parts stores) to get the filter out. New filter and tools the store should be able to tell you what's needed and slide hoses back on. Pressure release should be near intake manifold, firewall side. Make sure you wear goggles when you take old one off as well, lines and filter will retain some fuel.
I install new fuel pump & fuel filter. I have 1994 Ford Ranger and I remove the truck bed. You can hear the pump working. The relay click on and gas come out the gas railing. Try to crank the check ...
1994 Ford Ranger STX Standard Cab SB
-
Maintenance & Repair
1997 Ford Ranger XLT Standard Cab Stepside SB
-
Maintenance & Repair
OK I'm having a problem getting my truck to start it died on my a couple days ago and would fire back up fuel pump is good I replaced the fuel filter and the pressure regulator and still will not f...
1992 Ford Ranger XLT Standard Cab LB
-
Maintenance & Repair
Truck loses power. Might run few minutes or might run a week before it does it again. Replaced ignition module, gas tank, fuel pump and filter. No change. Let it set 10-15 minutes and it will star...
1994 Ford Ranger XLT Standard Cab SB
-
Maintenance & Repair
I have a weird problem where my something in my electronics for my fuel pump and radio works occasionally I'm not too sure where this issue may be but I found a direct correlation with my fuel pum...
1988 Ford Ranger XLT Extended Cab 4WD SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.