You may have to disconnect and clean the battery and connections, then reconnect and drive it some to reset any code. if it resets the same code, you need to read and perform the tests indicated by the code. It can be injector on time is at stake, or injector issues. there is too much fuel present after combustion i expect. If you are behind on maintenance, this is a good time to find out and get that done with trying to get the codes to clear.
cant figure what is causing this code too come on changed the mass air flow sensor and that didnt help code p0172
2000 Mitsubishi Eclipse GS
-
Maintenance & Repair
cant figure what is causing this code too come on changed the mass air flow sensor and that didnt help
2000 Mitsubishi Eclipse GS
-
Maintenance & Repair
After my car is fully heated up, it puts out black smoke and runs rich. After doing research it says that the ECU/ECM could be bad. When I searched for the part on NAPA website it says that rarely i...
1992 Mitsubishi Eclipse GSX Turbo AWD
-
Maintenance & Repair
I put my codes in and no sound to speakers
2001 Mitsubishi Eclipse GT
-
Maintenance & Repair
I have a very well maintained '05 Eclipse with the 2.4, manual trans. My problem comes and goes. Problem is: At half to full throttle the engine will bog down & fall flat on its face, I can even get...
2005 Mitsubishi Eclipse GS
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.