maf sensor and air intake duct . replaced the maf sensor and housing twice & throttle body tps sensor as well. replaced iac sensor &pvc valve (everything checked). there is no leaks in the hoses or intake. the electrical wires are getting power at the connecting ends of theses sensors. disconnected the maf sensor and is running fine. when plugged back back up; it stall and cut off each and every time. can you help or give me some directions. 1998 ford explorer 4.0 sohc

maf sensor and air intake duct . replaced the maf sensor and housing twice & throttle body tps sensor as well. replaced iac sensor &pvc valve (everything checked). there is no leaks in the hoses or intake. the electrical wires are getting power at the connecting ends of theses sensors. disconnected the maf sensor and is running fine. when plugged back back up; it stall and cut off each and every time. can you help or give me some directions. 1998 ford explorer 4.0 sohc 1 Answer

I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would stop. I have changed the EGR valve, the IAC valve and the fuel regulator. Also I have replaced all of the hoses that go to the upper intake and the upper intake gasket. I just cleaned the MAF sensor with MAF sensor spray cleaner and now the the check enging light is on and it hesitates when I drive. but the rpms are steady as to where before they were all over the band. any Ideas 4 Answers

I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would...

Where is the intake air temperature sensor and how do i get to it to change it? 1 Answer

2005 Explorer 4.6 SOHC - getting code for intake air temp failure. I thought it was the one right behind the alternator - but I now think that sensor is the head or cylinder temp sensor. Can someone...

Hi i have a FORD EXPLORER 4L V6 1997 i it dont want to start we check the fuel pump and spark plugs and thats fine when you start it back fires by the part where the air filter is can it be a valve or timing chain . 2 Answers

the van did drove the morning i stopped at a friends house and when i tried to start again it started to do this.

I have a 1998 Ford Explorer, the temperature gage works fine, and there is plenty of antifreeze in the reservoir and the radiator. I select the controller for the front heat NO HEAT & NO BLOWER. 3 Answers

I have a 1998 Ford Explorer that blows COOL air in the rear. The rear control cluster works fine. But when it comes to the front control cluster, THERE IS NO HEAT, & NO BLOWER. I have filled the rese...