On a 4spd automatic trans, Is the input shaft suppose to slid in and out ?

Asked by Guru955M9N Dec 30, 2020 at 09:15 AM about the 1999 Ford Ranger XL Standard Cab Stepside SB

Question type: Maintenance & Repair

I have a mechanic replacing my 4spd automatic trans, The input shaft does
not come out? Is it suppose to slide in and out freely?

Guru955M9N answered 3 years ago

Ok, What would be the possible issue if it doesn't??

Mark helpful

Guru955M9N answered 3 years ago

I don't see where to find your answer to what is probably wrong if shaft doesn't move?? Thank You

Mark helpful

Your Answer:

On a 4spd automatic trans, Is the input shaft suppose to slid in and out ? 2 Answers

I have a mechanic replacing my 4spd automatic trans, The input shaft does not come out? Is it suppose to slide in and out freely?

1999 Ford Ranger XL Standard Cab Stepside SB

-

Maintenance & Repair
2003 FORD RANGER 4.0 AUTOMATIC CYCLES IN AND OUT OF OVERDRIVE WHEN IT IS ENGAGED. 2 Answers

At any speed, and while the cruise control is engaged, the transmission cycles in and out of overdrive about every 5 seconds resulting in an approximate increase of 600 r.p.m. each time.

2003 Ford Ranger 2 Dr XLT 4WD Extended Cab SB

-

Maintenance & Repair
I own a 1985 Ford ranger xl 4x4 and have had the transmission rebuild twice. The mechanic doing the wor stated to me that the camshaft may have too much play and is causing the seal in the transmission to foul/leak. is this a poss 1 Answer

can a un-balanced crank shaft cause transmission seal leakage? Mechanic says sloppy camshaft can cause transmission seal leakage, He rebuilt My transmission and it's back in the shop 2500 miles or so...

1985 Ford Ranger

-

Maintenance & Repair
i have a 1989 ford ranger 2.3L engine and manual 5 speed trans. my truck will not idle as long as the alternator is plugged in but idles and runs fine with it unplugged 2 Answers

i have replaced the alternator, the voltage regulator connecter plug, the battery, the cylanoid,the crank sensor, put a new timing kit on it, and replaced the fuel pump and fuel filter but my truck st...

1989 Ford Ranger

-

Maintenance & Repair
I have a 2001 Ford Ranger automatic I was getting on the freeway and it kept giving itself gas accelerator stuck but there's a pedal next to the right hand side of the accelerator what does that pedal 2 Answers

I have a pedal on the right hand side of my accelerator it's a small pedal I don't know what that's for can you help me

2001 Ford Ranger XLT 2 Door Styleside LB RWD

-

Maintenance & Repair

Looking for a Used Ranger in your area?

CarGurus has 697 nationwide Ranger listings starting at $6,445.

Used Ford F-150

304 Great Deals out of 13,517 listings starting at $3,888

Used Toyota Tacoma

41 Great Deals out of 798 listings starting at $9,975

Used Nissan Frontier

15 Great Deals out of 552 listings starting at $8,688

Used Chevrolet Silverado 1500

164 Great Deals out of 7,371 listings starting at $6,995

Used Toyota Tundra

32 Great Deals out of 941 listings starting at $10,698

Used GMC Sierra 1500

150 Great Deals out of 7,862 listings starting at $4,944

Used Ford Mustang

31 Great Deals out of 1,627 listings starting at $7,999

Used Jeep Wrangler

130 Great Deals out of 5,959 listings starting at $2,995

Used Toyota 4Runner

22 Great Deals out of 528 listings starting at $7,700

Used Chevrolet S-10

2 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

On a 4spd automatic trans, Is the input shaft suppose to slid in and out ?

2 Answers

Your Answer:

Looking for a Used Ranger in your area?

Shortcuts

Search Ford Ranger Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

On a 4spd automatic trans, Is the input shaft suppose to slid in and out ?

2 Answers

Your Answer:

Related Questions