How to get timing back set
i have a 2003 isuzu rodeo with 2.2. it was running before i replaced the water pump but
after all parts put back on it will not start. it will spin over but not fire. what marks on
the the exhaoust cam gear do i line up with. One has a triangle with exhaust and
another has intake and the ther is one more with a just a notch. Next question is the
crank there is a small mark on balancer ( which location should that be at the 6 12 or 1
Delete the space between (- 3) should look like (-3) in address. Sorry iPad issues again.
This is labeled 2000 but it is the 2.2 ..click on it to see it
Good morning David. Yes that is the same as the 2003.
I was not trying to make it seem like my answer is better, sometimes an image is good is all...good morning yo own self dandy
It's all good. I just can't import pictures with this iPad like you do. Lol
I took that down..didn't come across right about the camshaft locking tool. It has to do with the interference engine, and while timing it does not have to be running to bend a valve ..and the answer is 6 o'clock on the crank
Yes I afraid they might have already bent some. But hopefully they didn't learn the same lesson I did about interference engines. When you do get belt on and timing marks lined up properly if it still won't start or run properly then do a compression check. Any cylinders showing 0 psi or extreemely low psi will indicate bent valves. But don't worry not that hard of a fix. Just remove head and replace bent valves and valve guide seals.
I change the crankshaft seal on 2000 Holden Rodeo 3.2 and I line up the marks on it but when I turn the it will crank but don't go. Joe
my Question is do u have picture of were point of the timing belt on a izusui 2003