bend pins on relay, socket melts and wires fall out under fuse box because relay gets hot well driving check wires first and bend pins has happen to me..
I have similar problem. control voltage to relay only 7 volts. relay will not switch on to run the pump. Also, I have shorted the pump terminals to make it run, but it will not pressurize and shut off. Any thoughts William?
I can manually kick it on and the pump will run but still won't start .there is no reset switch . what would cause the relay not to kick on
2002 Hyundai Accent GS 2-Door Hatchback FWD
-
Maintenance & Repair
Last month the fuel pump went bad. I replaced the fuel pump and found that ECM relay had caused the fuel pump issue (had a windshield leak). I resealed the windshield and replaced the relay. The ve...
2004 Hyundai Accent GL Sedan FWD
-
Maintenance & Repair
Where is the starter relay on a 2011 Hyundai accent
2011 Hyundai Accent
-
Maintenance & Repair
The car will crank but won't start have checked everything but the relay switch and the fuel pump only because cant find either one...
2012 Hyundai Accent
-
Maintenance & Repair
The fuel-pump is new I t was just put in the relay was checked . But yet the power is not continuous.
2003 Hyundai Accent
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.