Maint

The P1000 DTC code is a manufacturer specific trouble code, it means that the OBD-II monitor testing is not complete. The P1270 code is set when the rpm or speed fall out of calibrated range. The vehicle has been operated in a manner which caused the engine to exceed a calibration limit. Code B1869 Air Bag Warning, may have the following causes: Blown Air Bag, Air Bag harness is open or shorted, Air Bag poor electrical connection to circuit, Faulty Restrain Control Module (RCM). Code c1095 failure in the circuit for the ABS hydraulic pump motor. it can be the wiring, the pump motor or the ABS module. Operating voltage required to run the hydraulic pump motor is in a range between 10 and 17 volts. This information is from my Ford Shop Service Manual, Revised July 2005. I would start by checking the brakes system and then move to the air bags. It is strange that, at least, the check engine light or the abs warning light did not come on, the manual reminds the technician to reset the PCM after job is finished. Hope this helps.