1986 Ford Bronco 2

Asked by jpkostura Sep 28, 2018 at 11:40 AM about the 1986 Ford Bronco II XLT 4WD

Question type: Maintenance & Repair

1986 Bronco 2 EFI 2.9  wont start. I just purchased Bronco 2. Vehicle cranks over but will not run unless I spray starter fluid in it. I have replaced in tank fuel pump and fuel pump relay.  

2 Answers

10

Do you hear the fuel pump engaging when you turn the key on? I had the same problem on my 1988 Ford Bronco 2 and I had a loose wire in the wiring harness. I was only getting 9 volts so the relay was not operating. Once I repaired the wiring, the fuel pump engaged and the engine started right up.

1 people found this helpful.
50

Very nice looking Bronco2 I do hear fuel pump engaging. Replaced internal pump and fuel regulator by the distributer. No pressure at the schrader valve. Starts for a few seconds with starting fluid, but no fire without starting fluid. Do you have any suggestions. Thank you in advance.

3 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    1,220
  • #2
    Colin Rivet
    Reputation
    240
  • #3
    Christopher Brownfield
    Reputation
    230
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Bronco
14 Great Deals out of 2,035 listings starting at $40,995
Used Jeep Wrangler
133 Great Deals out of 5,940 listings starting at $8,990
Used Toyota 4Runner
35 Great Deals out of 557 listings starting at $9,999
Used Ford F-150
315 Great Deals out of 13,805 listings starting at $4,500
Used Ford Ranger
17 Great Deals out of 709 listings starting at $8,999
Used Ford Mustang
38 Great Deals out of 1,626 listings starting at $8,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.