heath31689 answered 5 years ago
use blue thread locker on the stud tighten down and you should be good to go thread locker keeps the nut from backing off
Crew_Chief answered 5 years ago
Try using a locking nut or if you have enough thread length, use a lock washer.
There is a wiper recall for this year. Did you check this out?
Replaced wiper transmission after replacing wipers not working nut keeps loosening up to motor n I had it tight what am I doing wrong?
2013 Chevrolet Equinox 1LT FWD
-
Maintenance & Repair
So my daughter went to start her car and the battery acted dead, it was just clicking. Later she went back out to start it and it started. But the hazards came on. She didnt touch them. Then i wen...
2012 Chevrolet Equinox
-
Maintenance & Repair
Driving home in rain on Turnpike, my wipers moved past the windshield on drivers side and stopped working. I checked fuses, they look fine, took off wipers and cleaned groves but motor sounds like ...
2010 Chevrolet Equinox LS AWD
-
Maintenance & Repair
I have 2010 chevy impala LS that has wiper issues. Installed new multifunction wiper switch, motor, and fuse. Wipers will not run on high speed or shut off in the proper position. I'm not sure I ha...
2010 Chevrolet Impala LS FWD
-
Maintenance & Repair
Where is the fuse for winshield wipers?
2000 Chevrolet Blazer LS 2-Door RWD
-
Maintenance & Repair
CarGurus has 2,997 nationwide Equinox listings starting at $1,695.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.