i'm looking at an01 dodge interpid with a new fuel pump and filter also timing belt and plugs yet the engine will die while i'm driving it restarts but on restart the engine will idle very rough and

i'm looking at an01 dodge interpid with a new fuel pump and filter also timing belt and plugs yet the engine will die while i'm driving it restarts but on restart the engine will idle very rough and 1 Answer

2001 Dodge Intrepid will start, then die and fails to restart 1 Answer

I had the fault codes 168.4, 030.0, and 017.4 showing. I changed the 02 sensor. The car would not start. I was told the spark plugs needed to be replaced. I changed the spark plugs. Drove the car ...

how do you loosen the belt on a 2.7 litre engine on a dodge stratus where the alternator ,idoler and power steering pump is ? 2 Answers

i cant figure out how to get the belt off.

Temp gauge fluctuates, then reads hot and engine sputters during idle. When I turn off car, then wait a minute and start it again, it will fire up but not stay running. 1 Answer

At this point the temp gauge is over the 3/4 mark to Hot and if I wait for the car to cool down it cranks up and runs fine. Is this a thermometer issue or a computer issue? The coolant level is fine...

I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...