Replaced 2 cv axles, and front drive shaft in my 06 mountaineer. Now AWD won't engage, and always can't lock in in 4x4 with the setup button. Any ideas?

Asked by Robert Dec 12, 2019 at 04:26 PM about the 2006 Mercury Mountaineer Premier AWD

Question type: Maintenance & Repair

6 Answers

EDIT** Replaced both front CV Axles, and front drive shaft in 06 Mountaineer. Now AWD won't engage. Also can not lock it in 4x4 using the setup/info buttons. Any ideas?

Bob is on the right track. Perhaps something was damaged or disconnected during the axle replacement.

Look up a diagram of the vacuum system for the front axle and then take a look.

When we removed the passenger side axle, a bearing or gear came out with it. we were able to lightly tap it off and slide it back in. But could that be part of the problem?

Your Answer:

Mountaineer

Looking for a Used Mountaineer in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    860
  • #2
    taver91
    Reputation
    570
  • #3
    kbro
    Reputation
    550
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Explorer
59 Great Deals out of 1,883 listings starting at $6,990
Used Toyota 4Runner
26 Great Deals out of 536 listings starting at $14,791
Used Chevrolet Impala
4 Great Deals out of 127 listings starting at $3,495
Used Ford Escape
132 Great Deals out of 4,197 listings starting at $3,999

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.