97 Chrysler Town and Country 3.8 if I use an AC compressor bypass pulley will that affect anything else other then no air conditioning?
Asked by Chryslerowner Sep 02, 2013 at 06:48 AM about the 1997 Chrysler Town & Country LXi LWB FWD
Question type: General
7 Answers
migration_judge_roy answered 11 years ago
could you simply NOT engage the compressor? a "compressor bypass pulley" would mean a new belt...a lot of fiddling around under the hood...just leave that bazooba switched to off~
Chryslerowner answered 11 years ago
It is still grinding with the ac off
migration_judge_roy answered 11 years ago
okay, get a new component belt tensioner...and belt. the tensioner arm is weak and/or the pulley's bearings are worn.....NEW tensioner and belt please...~
Chryslerowner answered 11 years ago
As you can tell I do not know much about my vehicle, thank you so much for this insight. I was not sure which direction to go. I will take your advice and have that replaced. Thank you.
Dorman® OE Solutions™ - Air Conditioning Bypass Pulley Part # 2100053 -- orielly auto parts has this one listed as a direct fit for your vehicle. Will probably use the same belt that your ac currently uses.
migration_judge_roy answered 11 years ago
"still grinding with the a/c off"....may not be the a/c~ like as previously asserted the idler is worn and the tensioner may be out of alignment~
migration_judge_roy answered 11 years ago
okay yes tennis-, will defer to your experience....have not have this problem on Any of my vehicles...cross your fingers....often thought that a "hermetically sealed" arrangement must have a magnetic coupler...of course refrigerators are able to get two wires into the "hermetic" seal....A/C an axle shaft for the compressor...but to be a true hermetically sealed unit would have no interruption as Freon (or equiv) is able to escape through a very small area (re-charge your system) which if hermetic would NOT need recharging~
