Rhodes2345 answered 8 years ago
drive line could be ujoints going bad could be bad tire bad wheel. any other noise like a clunk when you take off or shift into gear. you need to check your ball joints and tie rod ends, wheel bearings.
Rhodes2345 answered 8 years ago
i don't think so but maybe 1st is the shake best felt in the seat or steering wheel
It shake at30-45 what can it be
1995 Chevrolet Blazer LS 4-Door 4WD
-
Maintenance & Repair
My third gear in my transmission is stripped and I'm trying to figure out if we don't have money what transmission year models will work in the 95 Chevy Blazer GMC
1995 Chevrolet Blazer 4-Door RWD
-
Maintenance & Repair
Yes can someone please tell me why my brake pedal on my 95 Blazer is very very stiff can't press send maybe one to two in at best and very hard to stop and when I press in at all it makes a loud h...
1995 Chevrolet Blazer 4-Door RWD
-
Maintenance & Repair
95 blazer 4.3 4x4 4 door transmission shifts hard into 3rd gear and wont shift into overdrive what transmissions will inter change with this one?
1995 Chevrolet Blazer LT 4-Door 4WD
-
Maintenance & Repair
My blazer turns on but only runs up to 10 mph even when your putting gas and it completely dies at stops i changed the fuel pressure sensor and two others that were marked at my local autozone i s...
2003 Chevrolet Blazer LS 2-Door RWD
-
Maintenance & Repair
CarGurus has 935 nationwide Blazer listings starting at $21,685.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.