I found out that the mechanic replaced the valve cover gasket but failed to replace a couple of crush washers when bolting the cover back on and also the gasket was crimped. Had to go to a Jaguar dealer and they corrected it for basically the same price. This Jag dealer treats me good with service and price, sometimes you still have to go to the experts. Lesson learned
2004 Jaguar S-TYPE 3.0L V6 RWD
-
Maintenance & Repair
car is dead and inside trunk button or car remote will not open trunk ! Can not jump battery as its in trunk?
2000 Jaguar S-TYPE 4.0L V8 RWD
-
Maintenance & Repair
after my mechanic replaced the ignition coil and sparkplug on cylinder 7 and fixed any wiring as well, #7 cylinder will misfire and engine light comes on after a driving for a little while. This has h...
2002 Jaguar S-TYPE 4.0L V8 RWD
-
Maintenance & Repair
hello I have a 2005 jag s-type 3.0 and my a/c is blowing hot air I saw where you recommend putting a cut off vale to stop the flow of hot water, where did you installed the valve and what type of valv...
2005 Jaguar S-TYPE 3.0L V6 RWD
-
Maintenance & Repair
Took car in to local shop after computer diagnosis for spark plugs, coil and intake manifold. Repair was done. Mechanics ran car a bit and later they said they heard a noise and engine locked (coul...
Jaguar S-TYPE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.