Just did head gasket on buick machined heads 3angle valve job magnafluxed put together no water flow pulled thermostat, nothing wondering can you bolt heads on backwards cause waterpump worked fine

Asked by Kevin Aug 02, 2015 at 02:20 AM about the 2000 Buick Park Avenue FWD

Question type: Maintenance & Repair

Could heads on backwards or lower
intake gasket backwards stop water
flow

157,455

Bob answered 8 years ago

Possibly wrong head gaskets or installed wrong covering the cooling passages.

1 people found this helpful.

Mark helpful

Your Answer:

Just did head gasket on buick machined heads 3angle valve job magnafluxed put together no water flow pulled thermostat, nothing wondering can you bolt heads on backwards cause waterpump worked fine 1 Answer

Could heads on backwards or lower intake gasket backwards stop water flow

2000 Buick Park Avenue FWD

-

Maintenance & Repair
My 1989 Buick Park Ave 3800v6 has been running fine, on the way home the other week, my car stalled while driving, It started up fine then died again, after a few more attempts it started and ran fine. Drove a few hundred more miles, and it stalled again, as I was pulling over I was trying to give it gas, when it made a large boom sound, blew the exhaust apart at the clamp and caught the ground on fire underneath my car, we moved it from the fire, Just a little char from the burned up oil underneath, Nothing electrical burned, Car is still ok, besides the exhaust needing to be put back together.. What could cause the stalling, and choke and backfire? I cleaned the MAF and throttle body the night before this incident. 1 Answer

The car has stalled out twice, gasping for air, first time I shut off ignition and waited and got it started again. Second time I was pumping the fuel too many times and it back fired and caught the g...

1991 Buick Park Avenue Ultra FWD

-

Maintenance & Repair
Water on Rear Passanger Floorboard 03' Buick Park Avenue Ultra 1 Answer

About 3 weeks ago I started having water show up on the rear passanger floorboard (and only there: none in the front floorboard or the trunk). At frist I thought it might be that one of my kids had...

2003 Buick Park Avenue Ultra FWD

-

Maintenance & Repair
is the water control valve necessary on a 1997 buickpark avenue 1 Answer

there is a backflow valve in the inlet to the heater on this car. I believe it is called a "water flow control valve". Mine has discinerated while I was replacing the intake manifold bypass asm ( aslo...

1997 Buick Park Avenue FWD

-

Maintenance & Repair
I asked question last night i just did head gaskets on my buick having same symptoms as before no water in oil but its like its putting compression in cooling system 3 Answers

I asked question about backward head gaskets and intake backwards i know not those replaced both head gaskets same time and cant put intake gaskets backwards please help dont know what it could ...

2000 Buick Park Avenue FWD

-

Maintenance & Repair

Used Buick LeSabre

1 listing

Used Chevrolet Impala

8 Great Deals out of 133 listings starting at $3,495

Used Lincoln Town Car

3 listings

Used Buick Regal

28 listings starting at $6,995

Used Toyota Avalon

40 listings starting at $6,995

Used Cadillac DeVille

6 listings

Used Ford F-150

310 Great Deals out of 13,812 listings starting at $3,800

Used Toyota 4Runner

28 Great Deals out of 545 listings starting at $9,999

Used Pontiac Bonneville

2 listings

Used Lexus LS

30 listings starting at $5,995

Used Lincoln Continental

12 listings starting at $21,880

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Just did head gasket on buick machined heads 3angle valve job magnafluxed put together no water flow pulled thermostat, nothing wondering can you bolt heads on backwards cause waterpump worked fine

1 Answer

Your Answer:

Shortcuts

Search Buick Park Avenue Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

Just did head gasket on buick machined heads 3angle valve job magnafluxed put together no water flow pulled thermostat, nothing wondering can you bolt heads on backwards cause waterpump worked fine

1 Answer

Your Answer:

Related Questions