Ive had my 2001Park Ave looked at and they said it needed the body control module and had to go to the dealership as it would have to be reprogrammed. Any idea what this would cost?

Ive had my 2001Park Ave looked at and they said it needed the body control module and had to go to the dealership as it would have to be reprogrammed. Any idea what this would cost? 1 Answer

My 1989 Buick Park Ave 3800v6 has been running fine, on the way home the other week, my car stalled while driving, It started up fine then died again, after a few more attempts it started and ran fine. Drove a few hundred more miles, and it stalled again, as I was pulling over I was trying to give it gas, when it made a large boom sound, blew the exhaust apart at the clamp and caught the ground on fire underneath my car, we moved it from the fire, Just a little char from the burned up oil underneath, Nothing electrical burned, Car is still ok, besides the exhaust needing to be put back together.. What could cause the stalling, and choke and backfire? I cleaned the MAF and throttle body the night before this incident. 1 Answer

The car has stalled out twice, gasping for air, first time I shut off ignition and waited and got it started again. Second time I was pumping the fuel too many times and it back fired and caught the g...

2003 Buick Park Avenue - My service light is on and one mechanic said I needed to replace the fuel sending module. What does that en-tale and do I have to drop the fuel tank? 5 Answers

I am getting close to have to do the emissions test and the mechanic told me all sorts of horror stories about dropping the tank and at least $1,000+ repair. He said I had to replace the whole fuel ...

When I turn the ignition key on to start my 2002 Buick Park Avenue 3800, the fuse blows for the ignition control module. Is this a common issue and where would I start troubleshooting on this problem? 6 Answers

The 10 amp fuse for the control module blow as soon as the key is turned to the run position.

?? Help ??had my coil , bearing and clutch plate on my ac and said it may be a fuse ( easy fix ) . Now it does not engauge any thoughts ? 2 Answers

They replaced the coil , bearing and plate and said it may be a fuse ( easy fix ) it had locked up when the bearing went bad and would not turn over . Had to remove belt to crank . Now ac won't w...