ram will not start
today i replaced the pcm on my 98 ram 1500 i have also replaced the cam senor in the
dist the crankshaft senor made sure the rotor was turning when cranking i have no spark
to coil or plugs i tried another coil still n/g i have fuel pressure on fuel rails i have ck the
nue safety sw -still nothing i even did a compression test on #2 cylinder 150 psi the fuses
all are ok even asd please help im running out of patients and so is my wife
Did you replace your ignition control module ?
The PCM you replaced,did numbers match old Pcm?
when i use a scanner to see if i have and codes my scanmner reads link error i have tried two scanners is there something else should i ck the gas guage also reads empty and i know i have a full tank i also pulled a plug and it is dry
Check the fuel rail for fuel,may be bad fuel pump or relay,
All so a bad fuel pressure regulator will do this.
i checked fuel pressure on the fuel rail and i got 40psi when eng was cranking
Have you checked the crank sensor?You said you already replaced cam sensor.
Did you just check it or replace it?
but the main problen is i have no spark after replacing the pcm cam senor and crank senor also asd
replaced
PCM,
where or can i reflash my ecu i got another ecu for my ram but still does not start i cant move the truck as i have to replace the rear end since i broke an axle please help
can a computor with the code 347ac be used on a truck with the code 347ae
i have a question i found two letter codes on my ecu i found one nuber 347ac and another number on the ecu with the number and ag which code do i use
no spark to coil 98 ram 1500 sport 5.9 wire from harness to coil has power wire from coil to ecu has no power replaced cam senor-crank shaft senor and ecu twice all the fuses and relays ck out ok battery is ok replaced coil is there an inline fuse i am not finding or a ballast resistor some place fuel pump runs all the time ob2 reads link error im at my witts end please help
98 ram 1500 5.9 cranks no start no power to coil fuel pump runs the time unless you jump out asd -fuel pump relay link error with ecu unless asd- fuel pump relay jumped out replaced ecu-crankshaft senor cam senorno codes on ecu.replaced ign coil all fuses ok.
Digging too deep today is January 30th and after throwing almost $1,000 at my Dodge for the same issues I found out it was in the cylinder not receiving power it needs for the injectors to fire so I ran the constant power wire directly to the auto shutdown relay in the fuse box, and the negative that is a pulsating ground, run it directly to the ECM clear all your codes there's your fix goodnight ladies and gentlemen
Digging too deep today is January 30th and after throwing almost $1,000 at my Dodge for the same issues I found out it was in the cylinder not receiving power it needs for the injectors to fire so I ran the constant power wire directly to the auto shutdown relay in the fuse box, and the negative that is a pulsating ground, run it directly to the ECM clear all your codes there's your fix goodnight ladies and gentlemen
