I'm trying to find out where to connect it to on the engine
Asked by Rambousekt Aug 16, 2014 at 10:21 AM about the 2000 Chevrolet S-10 LS Extended Cab 4WD
Question type: Maintenance & Repair
Asked by Rambousekt Aug 16, 2014 at 10:21 AM about the 2000 Chevrolet S-10 LS Extended Cab 4WD
Question type: Maintenance & Repair
2000 Chevrolet S-10 LS Extended Cab 4WD
-
Maintenance & Repair
I have a ground wire hanging loose from the rear driver side frame rail near the fuel tank of my 1988 Chevy S10 Standard Cab 4x4 2.8 L V6 and can not find the other end to reconnect the two ends of ...
1988 Chevrolet S-10 Tahoe 4WD
-
Maintenance & Repair
1995 Chevy S10LS V6 TBI Engine Problem with a/c blower motor not working all the time Replaced blower motor switch and it still cuts in and out when it wants to Would the relay or the resistor cause t...
1995 Chevrolet S-10 LS LB RWD
-
Maintenance & Repair
Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...
1991 Chevrolet S-10 RWD
-
Maintenance & Repair
I broke my key in my ignition, I tried breaking out column to start with screw driver but didn't go as planned, How do I hot wire it? which wires do I need to connect?
2000 Chevrolet S-10 Extended Cab RWD
-
Maintenance & Repair
CarGurus has 2 nationwide S-10 listings and the tools to find you a great deal.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.