I have a 1995 LT 1 engine code P in a 1981 Corvete. If the engine temperature is to high will it cause the engine to shut down, until the engine cools?

I have a 1995 LT 1 engine code P in a 1981 Corvete. If the engine temperature is to high will it cause the engine to shut down, until the engine cools? 1 Answer

1981 corvette rod knocked a hole in oil mpan car will still run but motor shakes. 1.If a rod is broke or bent and went out the oil pan is the engine junk? 2.Is there any way of replacing just the bent or broke rod that put a hole in the oil pan 2 Answers

Can you take the broken rod out by taking the oilpan off to get to crankshaft to undo the broken or bent rod and can you get to the other end of the rod in the piston? Should the whole engine be rebui...

I have this engine installed in my Jeep, my temperature gauge is going crazy, it goes from looking like its warming up to all the way to the right as in hot! in no time, any advise? thank you 2 Answers

so as soon as I get on the road you can see the gauge going up to its regular temperature and just out of no where it goes all the way to the right and it stays there, I know for a fact my jeep is n...

what would or could pulling the codes on my 1990 corvette cause the engine not to start and module 4 to show an error code 4 Answers

my 1990 chevrolet corvette was left idling for 20 minutes and buried the needle into the hot side shut off then 20 min went to crank it sputtered and shut off after that i drove it a couple of times...

WOULD LIKE TO BUY A 1982 CORVETTE . WOULD LIKE TO REPLACE THE CROSS-FIRE ENGINE. WHICH MODERN UPDATED ENGINE WOULD BE BEST FOR THE 1982 CORVETTE? 18 Answers

THE CROSS FIRE FUEL INJECTION ENGINE SUCK.. NEED TO REPLACE THE ENGINE BUT DON'T KNOW WHICH WOULD WORK BEST AND FIT IN A 1982 CORVETTE. PLEASE HELP