'98 chevy silverado 2wd leaking pinion seal?
10

Asked by BriNM May 14, 2016 at 01:39 PM

Question type: Maintenance & Repair

I have a '98 chevy. Replaced the pinion
bearing and seal once already. It started
leaking so we replaced the seal a second
time and it is still leaking pretty bad. Any
ideas of what i need to do differently??? All
help is very appreciated!!

2 Answers
157,485

Bob answered 7 years ago

Check to see if a groove is worn into the part that the seal rides on. If it is grooved then there is your problem. The fix is to either replace the grooved part or use a speedi-sleeve to repair it if available.

Mark helpful
10

BriNM answered 7 years ago

There is a groove, thank you!! That is the conclusion we came to as well. We will fix this and hope it works!

1 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • '98 chevy silverado 2wd leaking pinion seal? 2 Answers

    I have a '98 chevy. Replaced the pinion bearing and seal once already. It started leaking so we replaced the seal a second time and it is still leaking pretty bad. Any ideas of what i need to do d...

    Maintenance & Repair

  • Pinion Seal 5 Answers

    well i plan on changing the pinion seal on my truck(10 bolt)....I was told to make sure and not over tighten the nut that goes into the crush sleeve....The question im asking is about how tight should...

    1994 Chevrolet C/K 1500 WT LB 4WD

    -

    Maintenance & Repair

  • 98 chevy silverado transylvania noise 20 Answers

    98 chevy silverado manual transmission is making a knocking noise only when I put the clutch in. Truck shifts fine the only other problem with it right now is the fuel injector. Need help with any...

    Chevrolet Silverado 1500

    -

    Maintenance & Repair

  • Does a leaking drive shaft pinion outer seal on a 1998 Jeep Grand Cherokee cause the internal rear differential pinion setup to lose its preload and need to be replaced. 1 Answer

    Is the following Jeep dealer guidance correct? The seal where the drive shaft pinion enters the rear differential leaks. It may have leaked for some time as it has sprayed the underneath of the body ...

    1998 Jeep Grand Cherokee Laredo 4WD

    -

    Maintenance & Repair

  • pinion seal/bearing replacement cost 2 Answers

    i have a 2000 grand cherokee larado with the 4.0 select-a-trac i need to have my front pinion bearing and seal replaced how much could that run at 75$ per hour

    2000 Jeep Grand Cherokee Laredo 4WD

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    245,040
  • #2
    Rowefast
    Reputation
    183,630
  • #3
    dandyoun
    Reputation
    169,320
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.