Your Answer:
Related Questions
-
ok, my driveshaft breaks at universal joints. i put it out of trans...i notice my pinion gear nut was loose. Is that the problem of driveshaft vibration then coming apart? 1 Answer
Maintenance & Repair
-
my 99' sebring was low on trans fluid and I put a half quart of the wrong fluid in. my trans went into "limp mode" (stuck in 2nd gear). i did a complete trans flush and this did not fix the problem. the transmission is still stuck in 2nd. can somebody please give me a solution that will not require replacing the trans? 6 Answers
my car was shifting hard into third gear and i checked the trans fluid to notice it was low. i added a half quart of mercron and my car started acting up horribly having a hard time shifting into any ...
1999 Chrysler Sebring LXi Coupe FWD
-
Maintenance & Repair
-
the drive shaft on my 1975 chevy suburban catches and/or bucks when i put it in gear or when the driveshaft is turning 12 Answers
when i put my 1975 chevy suburban in gear or when im driving, the driveshaft catches and/or bucks alot
1975 Chevrolet Suburban
-
Maintenance & Repair
-
Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from under the truck.I looked around and couldn't see anything visibly wrong.I started it up again just fine and started rolling in 1st gear, then I tried to shift to 2nd the truck just stopped and wouldn't go into any gear.At this point the truck will start but when I let the clutch out, it dies(in neutral). Had to remove my drive shaft to be towed on towrope because it wouldn't roll smooth in neutral. When the engine is running now I don't feel any vibration through the gearshift anymore like how I used to before it broke down. What could it be? 3 Answers
Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...
1991 Chevrolet S-10 RWD
-
Maintenance & Repair
-
my 2007 nisan titan was in a rear-end accident, and after getting it from the body shop in about 2 to 3 week i start to hear a grinding noise. i had it checked out at Nissan dealer and they said that the Center support Driveshaft was split and also there is internal damage to the rear Differental. Could this have been caused by the rear-end accident? 1 Answer
my 2007 nisan titan was in a rear-end accident, and after getting it from the body shop in about 2 to 3 week i start to hear a grinding noise. i had it checked out at Nissan dealer and they said that ...
2007 Nissan Titan Crew Cab LE
-
Maintenance & Repair
Search Maintenance & Repair Questions
CarGurus Experts
-
#1Gene ArnettReputation245,200
-
#2RowefastReputation183,910
-
#3dandyounReputation169,380
Find great deals from top-rated dealers
SearchContent submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.