My 2002 Nissan maxima se is apparently missing the front stabilizer bar (was driven over a concrete median before I bought It). My question is: Is the bar one piece that goes the width of the car ? All I can find are sway bar links.. Help anyone ??

My 2002 Nissan maxima se is apparently missing the front stabilizer bar (was driven over a concrete median before I bought It). My question is: Is the bar one piece that goes the width of the car ? All I can find are sway bar links.. Help anyone ?? 3 Answers

how do i fix my front pass side wheel from moving back and forth i dont know the name of the par but it is a long black bar that goes from the strut houseing into what looks likure that wiloe near the transmission the bar is good but the rubber bussings i think are gone where can i find a picture of the part so i know exacly what it is 2 Answers

I can take my front pasinger wheel and move it left to right about an inch both ways

what is the name of the (stabilizer/sway bar)that runs across the front of the rear axle? 1 Answer

I would have to say it is approximtley 1/2 inch in diameter. It has bushings on it by the frame, and goes from Drivers side, just inside the wheel to passenger side just inside the wheel

my Chrysler 300 makes a thud noise when i go over a bump. I have replaced the struts, tie rods and sway bar end links and it still makes that sound. 4 Answers

my Chrysler 300 makes a thud noise when i go over a bump. I have replaced the struts, tie rods and sway bar end links and it still makes that sound.

I JUST BOUGHT A ORIGINAL 74 Z-28(1974)(4 SPEED TRANSMISSION) ,IT WAS FACTORY ORDERED IN 1973,ANYWAY WHERE CAN I FIND REVERSE ON IT..I HAVEN'T DRIVEN CAR YET AND AS WELL MY KEY IS STUCK IN THE IGNITION, THANKS IF ANYONE CAN HELP... 2 Answers

1974 Z-28 FACTORY 4 SPEED, WAS ORDERED IN 1973 ,HAS POINTS IGNITION hAVE NOT DRIVEN CAR YET AND I'M STILL LOOKING FOR WHERE IS THE REVERSE GEAR ON IT...EXAMPLE IS IT LOWER RIGHT BOTTOM..SO FAR I CAN ...