97 dodge ram 1500 318 engine replaced tranny and now the truck has no power we also changed the crank sensor and that wasn't the problem what could be wrong any ideas no code come up on scanner ??

97 dodge ram 1500 318 engine replaced tranny and now the truck has no power we also changed the crank sensor and that wasn't the problem what could be wrong any ideas no code come up on scanner ?? 4 Answers

96 dodge ram 1500 with a 318. i changed out the asd relay and the crank relay and the one under the dis. capand still no spark.not getting any power to the coil. dont know what to check any more. 4 Answers

96 dodge ram 1500 with 318.wont get any spark out of coil.replaced the asd relay and the crank relay and the one under the dis cap.Im not getting any power to the coil eatherunless i take out the asd ...

My 94 dodge ram 1500, 5.2L, runs okay but began using lot of fuel. Had trouble codes 37, 32, and 51. Cleaned throttle body and checked for vaccum leaks or bad hoses. Code 32 gone away. Cleared code 51 which according to Haynes manual is not supposed to make the check engine light come on. Their is no code 37 in the Haynes manual for a gasoline engine on the 94 Ram. Their is for diesel engine. What is it, where is it at and how do I correct the problem. 51 I know is the O2 sensor. Truck runs great, shifts fine , but is still using more fuel than normal. Been reading about code 37 and transmissions, don't think my problem is there. Any help ? 5 Answers

Cannot get the Code 37 to clear, can disconnect the battery and the code 51 clears, The code 32 has not come back but 51 comes back. 37 does not go away. Engine light will not come on after starting...

My 1997 Dodge Ram 1500 Laramie 5.9L will cut out during acceleration and sometimes die. No check engine light comes on. What can be the problem? 1 Answer

Replaced the fuel pump about 6 months ago. Haven't had any problems in that regard since. I thought I would get an engine light if it was as O2 sensor.

i have a 2002 dodge 1500, 4.7. It will crank but not start, replaced the CAMshaft and crankshaft senors, replace all plugs, fuel tested ok, we can here the fuel pump engage, we have spark and that last thing we just did was changed all the timing chains (it was out of timing) but the truck still will not start. Help on what could be next? Thanks 42 Answers

2002 dodge 1500 4.7 cranks will not start.