could be your throttle position sensor or a vacuum leak
X2, if your throttle cable was out of alignment it would constantly run high, the vac system does a lot of work at engine start. A (hill billy) way to check for a vac leak is to spray water over the vac lines and watch for bubbles or smoke a cig.
Jeep Wrangler
-
Maintenance & Repair
My 2007 jeep was parked in the backyard, no one around it, key fob hanging up in the closet and the headlights randomly came on went off and came on again. It has done this several times. What coul...
2007 Jeep Wrangler X 4WD
-
Maintenance & Repair
The stop start a lite is on as well as check engine can I drive it to the dealer
2019 Jeep Wrangler
-
Maintenance & Repair
need to re install the emission equipment it came with for emission purposes The vehicle is a 1989 jeep wrangler from Canada. The previous owner gutted all the emission equipment The engine is an e...
Jeep Wrangler
-
Maintenance & Repair
car attempts to stall, engine light goes on and gas acceptance tube moves when you insert nozzle?
2012 Jeep Wrangler Sport 4WD
-
Maintenance & Repair
CarGurus has 5,937 nationwide Wrangler listings starting at $6,500.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.