where can I find control module N338
My 88 rx7 convertible is not running, only run with staring fluid.; good fuel
pressure. has 12volt on injector connector but no signal on the other terminal
from ecu when engine is crank or run
3 Answers
So there is no injector driver signal, check the crankshaft position sensor and wiring, if you can’t find the problem there then you need to find a shop that still has the old Mazda computer system checker to get the diagnostic codes.
Talk to your local auto parts store and see if they can send your old one out to be rebuilt or contact Cardone in Philadelphia, PA directly and see if they can rebuild your old one. You might get lucky and find one on Ebay too. That's where I found the BCM for my 94 Fleetwood. Hope that helps! Jim
