Asked by mustang_1989 Jun 29, 2007 at 05:43 AM about the 1993 Ford Mustang
Question type: Maintenance & Repair
on the upper intake the coolent hoses hook up front and back on a gt but on the cobra it only has a place for one hose..where does the back coolent hose go sinse there isnt a egr plate like on the gt?
on the upper intake the coolent hoses hook up front and back on a gt but on the cobra it only has a place for one hose..where does the back coolent hose go sinse there isnt a egr plate like on the gt?
1993 Ford Mustang
-
Maintenance & Repair
Where does the hose go that comes out on bottom of egr vaccum regulator not the two little hoses there are 2 spots for hoses like half inch hose goes straight down from regulator but dont know where t...
2002 Ford Mustang GT
-
Maintenance & Repair
my 1988 mustang gt convertible usually runs great but sometimes it idles up and down and will even die. the problem stops when i accelerate but will continue at cruising speed. sometimes it does not...
1988 Ford Mustang GT Convertible RWD
-
Maintenance & Repair
I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would...
1994 Ford Mustang GT Coupe RWD
-
Maintenance & Repair
ive changed the egr, tps, fuel pump/filter/sending unit, plugs and wires, fuel regulator
1995 Ford Mustang GT Coupe RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.