Try looking on Amazon. Walker 80871 or Magnaflow 36886 will work. Both are CARB compliant and direct fit, just unbolt the old one and bolt in the new one. When I replaced the cat on my MR2, the bolts were so rusted up I had to cut them off with an angle grinder. Good luck, hopefully yours is easier to remove.
you can have autozone order the California 50 state approved catalytic converter to be able to pass smog, walker or magnaflow, direct fit is better than universal. its best to go to a shop to have the original one removed and the new one saughtered on.
I need some place thatll carry a converter and to put it in, muffler shop etc. Hopefully a decent price for both. Im in rialto, ca. Please help! Email brandonnnboop@gmail.com
1986 Toyota MR2
-
Maintenance & Repair
I am having a very hard time tring to find some place to purchase a new glass sunroof for my 1993 MR2. I have been restoring my car and want to replace the glass as it has a crack in it but doesnt le...
1993 Toyota MR2
-
Maintenance & Repair
Basically, the battery dies. Not completely, but enough to where it will not start without a jump. I have taken it into the shop and have had all the shorts and grounds problems fixed, purchased a cou...
1985 Toyota MR2 STD Coupe
-
Maintenance & Repair
i bought it at 156, from the original owner first i replace the clutch, hydrological clutch master and slave cylinder. then drove for a while. one day i was driveing for about 30 mins or so and my car...
1995 Toyota MR2 2 Dr STD Coupe
-
Maintenance & Repair
Im sure adjustment is one thing, but does it need to be bled a little bit? Also could the slave or master cylinder be bad? Very important please help! 86 Toyota MR2
1986 Toyota MR2
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.