Check VSC system in Toyota Camry
Asked by Jvds Apr 21, 2016 at 12:02 PM about the 2006 Toyota Camry
Question type: Maintenance & Repair
In my Toyota Camry car I get check VSC system error
sometime and not solve yet error is come and my car not
get the pick up and I press acceleration paddle is fully but
not get pick up and sometime error come but car is going
on completely and getting the pick up... HOW TO SOLVE
THIS PROBLEM????
17 Answers
But our car is not hybrid
Auto_Centric answered 8 years ago
2006 Camry, check VSC system error, vehicle will move very slow not much pick up? when you press acceleration pedal? slowly gaining speed?
Slowly gain pick up and not go to above 80 speed and not go to particular
Not go to above 80-100 push full accelerate
Auto_Centric answered 8 years ago
Ok low power, I can only guess, speculation of trouble I think engine has miss. NON firing cylinder.. this can be caused from simply spark plug to ignition coil problem... V6 3.5 or the 2.4 engine?
Auto_Centric answered 8 years ago
Have it read for codes, even if the check engine light is NOT on the computer will have stored information and codes. Discount auto stores will read codes for no fee. write them down. A miss NO firing cylinder, can cause the VSC system error.
I don't know spark plug and problem with spark plug and ignition coil problem???
And now error it's gone automatically and error come automatically
Auto_Centric answered 8 years ago
When error is gone can Camry exceed / pass / Make more speed 80-100km? or still loss of power?
No gain speed is fast and get pick up fast but sometime error is here and car gain pick up like without error
Auto_Centric answered 8 years ago
Jvds 2006 Camry Advised to CHANGE accelerator pedal assembly. ITS A THROTTLE POSITION SENSOR WITH A PEDAL ATTACHED. A device controlling the flow of fuel or power to an engine.
Auto_Centric answered 8 years ago
Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without A/C) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position. Consequence: The accelerator pedal may become hard to depress, slow to return to idle, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash.
We already changed spark plug but problem not solve yet...!!!
did you ever figure it out?
My TOYOTA CAMRY XLE 2007 HAS THE VSC SYSTEM .Can i use a car or stop to use a car?
