Transmission after 2nd gear won't go into overdrive I replaced ecm and the white box in glove box area what can I do now to correct problem replaced trans 2 mths ago done good for 1 month
What next
Asked by Creolememphis Oct 18, 2016 at 01:20 PM about the 1994 Chevrolet C/K 1500
Question type: Maintenance & Repair
What next
What next
1994 Chevrolet C/K 1500
-
Maintenance & Repair
The clips on the plugs that go into the solenoids are broke. Can this be the problem?
1994 Chevrolet C/K 1500 Silverado Extended Cab 4WD
-
Maintenance & Repair
1989 Chevrolet 2 wheel drive truck, replaced transmission, worked afterwards but, skipped gears, in between 20ish mph to 50ish mph. First time replacing a transmission, filter was replaced/fluid goo...
1989 Chevrolet C/K 1500
-
Maintenance & Repair
timing chain slipped we replaced it reset all of that . turns over but gets no spark plugs and wires are new changed crank shaft sensor got a new battery still no spark what else can i do
1997 Chevrolet C/K 1500 Silverado Extended Cab LB 4WD
-
Maintenance & Repair
chevy suburban 5.7liter 4x4 silverado 1991,question i have fuel pressure the jets work i have power to the coil but no spark to the wires.i also have power to the black box on pass. side top of engi...
1991 Chevrolet C/K 1500 Scottsdale LB RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.