cloged fuel filter,weak fuel pump,
robbarlow97 answered 12 years ago
Check the connections between the ignition control module and the distributor. The module should fit SNUGLY into the connector.
1986 Ford Bronco II
-
Maintenance & Repair
The Bronco starts and runs good, but in the garage afterward it has a strong gasoline smell...
1989 Ford Bronco II Eddie Bauer
-
Maintenance & Repair
1986 Bronco II and I can not find the proportioning valve under driver seat in the frame. I can't find it, mechanic can't find it but according to any reading i have done, there has to be one for f...
1986 Ford Bronco II Eddie Bauer 4WD
-
Maintenance & Repair
My 1986 Bronco II is having starting problems! I can pull the map sensor hose loose an it will start right up...but if you try to reconnect the hose it will die. If I start with the map sensor lo...
1986 Ford Bronco II XLT
-
Maintenance & Repair
1986 bronco 2 runs great at idle. When dimmer switch is pulled, even with lights off, it kills the engine. Same when under load, in R or D, and your turn the wheel. Started with ECM, no luck. Checke...
1986 Ford Bronco II Eddie Bauer 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.