i just discovered my 1999 bmw e46 has a tear and crack on intake boot and engine stalls when you start it and eventually switches off but when i disconnect air flow sensor it works perfectly

i just discovered my 1999 bmw e46 has a tear and crack on intake boot and engine stalls when you start it and eventually switches off but when i disconnect air flow sensor it works perfectly 1 Answer

I PUT A 2000 5 SERIES BMW MOTOR IN MY 3 SERIES 1999 BMW AND USED THE WIRING HARNESS OFF THE ORIGINAL 3 SERIES WHICH I HAD TO AND NOW THE STARTS AND IDLES FINE WHEN YOU REV IT UP IT SPITS AND SPUTTERS 3 Answers

I PUT A 2000 5 SERIES BMW MOTOR IN MY 3 SERIES 1999 BMW AND USED TEH WIRING HARNESS OFF THE ORIGINAL MOTOR OUT OF THE 1999 3 SERIES AS i HAD TO BECAUSE THE WIRING HARNESS WAS DIFFERENT ON THE NEW MOTO...

Why does my bmw 320d 02 plate keep going in to limp mode when launching off start but when I start off slowly and then launch it works fine. I have had it plugged in and it come up low air pressure. 1 Answer

Also I can not plug my air flow mass meter in because it stays perm entry in limp ( the air flow mass meter is brand new)

1999 BMW 323i 4door Sedan.....My right front headlight has a wire coming off it and the I can really wee what that wire needs to be attached to it has the attacher still attched but it is just dangling? 2 Answers

It is coming off the left bulb assembly wire hoping to not have to take the bumper off ahve the car jacked up but I can't see to figure out what it goes too any help would be greatly appreciated

On my 1997 BMW 328is, the A/C works whenever it wants!! (on and off) 7 Answers

On my 1997 BMW 328is, the A/C works whenever it wants!! (on and off) When it works, it is find!! I think I have a short somewhere??? Any suggestions???