I have a 1993Chevy lumina it will not fire I have done change the coal pack and the modeler and have no spark still

I have a 1993Chevy lumina it will not fire I have done change the coal pack and the modeler and have no spark still 2 Answers

I have a 91 chevy Lumina it starts and runs at idle but when I hit the gas it stalls. 1 Answer

I have a 1991 Chevy Lumina 3.1 it starts and runs at idle but when I hit the gas it stalls whats the problem?

I have a 95Lumina LS that does'nt idle smoothly and acts like it has lost all power. I replaced the fuel pump and fuel filter . Do you think it could be the sensors or catalityc converter? 1 Answer

I this 95 lumina ls in 2011 and I have already had to replace the fuel pump/filter 3 times, along with a new ignition box, spark plugs/wires only to have it die on me in the middle of a major intersec...

I have a '99 Chevy Lumina LTZ, and for the first couple of years that I had it it would never really heat up until the past two years, when I noticed the temperature gauge actually moving. Anyway, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another year or so out of it without replacing anything major. 2 Answers

I have a '99 Chevy Lumina LTZ, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another y...

Chevy Lumina 91 3.1 4dr...multi...I got a codes, 14 and 42...14 is heat temp high...and 42 is a ESC or EST Eletric Spark Timing, now I went and got a paper clip to pull these codes...it works. 12,12,12, and 14,14,14 and then 4..2 so it is 42...42 is behind the coil pack and then also it is connected to the crank sensor...What ever it is...I did check spark on the to top right side coil pack and the spark is powerful...removing 2 plug wires to test spark...so under that, change that and then the crank sensor...and the the Heat sensor for the water or radiator 14 code. Any other helps is good...Thanks! 7 Answers

before it stalls engine light comes on all the time before it stalls...Code 42 and code 14 is what I got...I am going to change the crank sensor in the morning to see if this helps...but I am welco...